The rear case is fitted with a foam gasket to form a water-tight seal between
the instrument and the selected installation face.
Mounting Procedure
1 . Make sure
selected location is clean, smooth and flat.
2. Apply the
template (supplied) to the selected location and
mark the
for the fixing studs and the cable boss
3.
clearance holes for the fixing studs through
bulkhead. Remove the template.
4. Cut
clearance hole for the cable boss using a 50mm
diameter
cutter.
5. Screw the two fixing studs into the control head.
6. Pass the
cable and transducer tails through the cableboss
clearance hole.
7. Assemble
control head to the bulkhead and secure from behind using
the thumb nuts
Bracket Mounting
The ST50 Plus
can, as an alternative, be bracket mounted using the
Mounting Kii.
Because instrument breathes through the vent in the rear case, this bracket
is for interior use only.
Flush Mounting
A flush mounting kii is available for installations where a flush mount is required
or more desirable. Full installation instructions are provided with the kit.
