5
© 2012 Directed. All rights reserved.
Disarming without a Remote Control
To disarm the system when the remote control is not available use the
following steps:
1. Turn the ignition to the run position.
2. Press and release the Valet button* once within 10 seconds.
The system then disarms.
Note:
As a precaution, if programmed for Passive Arming the system
should be placed into Valet Mode until a remote control is available.
See Valet Mode section next for entry procedure.
Valet Mode
Valet mode disables the system so it can’t arm when passively arming
or when using the remote control to lock the doors.
To enter and exit Valet mode use the following steps.
1. Turn the ignition to the run position and then off
2. Press and release the Valet button* within 10 seconds
The status LED turns on when Valet mode is entered (or ignition is off)
and off when exited (or ignition is on).
Note:
When valet mode is enabled, the convenience features of your
system are still operational but the security features of your system are
not.
* The combined Status LED/Valet Button is generally located some-
where beneath the dashboard.
