To commission the gate, move the gate
approximately 1m from the fully open position and
tighten the knurled wheel (Clockwise) engaging the
clutch assembly
Press the opening button located under the dip
switches to begin opening cycle,
Ensure
the direction the gate travels is in
accordance with the opening and closing status
LED’s, if not reverse two of the motor wires at the
inverter terminals.
Inverter settings can be adjusted via the keypad i.e.
Opening speed, closing speed and ramp times.
Automation settings operating modes are able to be
adjusted via the CB6 board, refer to manual for
further instructions
Once Inverter settings are appropriately set proceed
to fine adjust the Limits for required operation
Summary of Contents for 750L I Range
Page 14: ...Single Controls Dual Controls ...
