11
ADVANCED PROGRAMMING, ADDING TO AND IMPROVING YOUR INSTALLATION
DEFINITIONS OF SAFETY INPUTS
Stop
Input connected to a push-button or switch placed outside the unit. It is employed to cause the gate’s immediate stop. This control is used
in an emergency situation.
Photo-cell
Input connected to an optical barrier. It detects and signals the passage of persons or vehicles in the area crossed by the gate or in the
nearby area.
Photostop
Input connected to an optical barrier. It detects and signals the passage of persons or vehicles in the area crossed by the gate or in the
nearby area
Opening Limit Switch
Input connected to a switch placed outside the unit. The switch operates when the gate has completed its opening phase.
Closing Limit Switch
Input connected to a switch placed outside the unit. The switch operates when the gate has completed its closing phase.
DEFINITIONS OF OUTPUTS
Blinker
Lamp’s on/off control. The lamp functions as a warning and optical signaller of potential danger for the gate’s motion.
Motor 1
Outputs for the opening/closure control of the motor which drives the first gate wing during the closing phase.
Motor 2
Outputs for the opening/closure control of the motor which drives the gate wing delayed during the closing phase. This wing can be
connected with an electric lock.
Electric lock
Impulse control for the electric lock release. The output can also control an open gate signalling lamp.
DEFINITIONS OF POWER SUPPLY INPUTS / OUTPUTS
AC IN (FS3 - FS4)
12Vac input for the electronic board power supply.
12Vdc OUT (Pay attention to the position of the Jumper JP1)
Power supply output for the photo-cells and/or any other accessory devices.
BATT IN (FS1 - FS2)
Input for a 12Vdc backup battery connection.
Attention: Set up the jumper JP2 in the right position in order to avoid damages of the equipment and/or battery.
DEFINITION OF ACCESSORY INPUTS / OUTPUTS
Antenna
Input for the connection of an antenna. This input can only be used if a radio receiver card is connected to the unit.
2nd radio channel
Auxiliary control output. To be used only if a two-channel radio receiver card is connected to the unit (J6 connector).
