p.
6/24
The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using this information for any purpose other than the
use of the products or the execution of the project to which it refers and from communicating it to third parties without prior written agreement of Automatic Systems. The document is
subject to change without notice.
CL 636-MT-EN
2.1 Connections to the electronic control board
A - Booth’s ON/OFF switch.
B - On switch emergency batteries after discharge.
1 - Connection with cable cv02A to door’s internal motor.
2 - Connection with cable cv01A to door’s external motor.
3 - Connection with cable cv03B to emergency batteries.
4 - Connection with cable cv07B to the internal door unlock magnet during an emergency.
5 - Connection with cable cv07A to the external door unlock magnet during an emergency.
6 - Connection with cable cv06A to the vocal message speaker.
Connection with cable cv13A lamp.
Connection with cable cv 14A to the intercom’s call button CE.
7 - Connection with cable cv08A to the power supply.
8 - Connection with cable cv12A the metal detector’s electronic control.
9 - Connection with cable cv14A to the emergency call button CE.
10 - Connection with cable cv11A to the internal proximity.
11 - Connection with cable cv10A to the external proximity.
12 - Connection with cable cv17A to the contact for the external rubber side.
13 - Cable cv18A connection to the internal rubber side and main board power contact.
14 - Connection with encoder cable to internal encoder.
15 - Connection with encoder cable to external encoder.
16 - Cable cv19A connection to the console.
17 - Cable cv05A connection to the internal push button panel.
18 - Cable cv04A connection to the external push button panel.
19 - Connection with loading cell cable to loading cell.
20 - Input connections:
- clamps 1 and 3 ON bridge.
- clamps 11 and 12 connection with cable cv09A to the mechanical lock.
- clamps 15 and 20 on first entrance bridge.
21 - Outputs connections.
22 - Connection with cable 5806791 to the SUN system (only booth’s with SUN system).
23 - Connection with cable 5806791 to the
Automatic
Systems
Metal Detector with digital console.
24 - Led self analysis.
25 - Connection with cable cv20a to the external mobile guide.
26 - Connection with cable cv21a to the internal mobile guide.
