Owner Installation Instructions
Axess® Pro Series 3100
33
The selectable functions available are:
RX = Off
From the time when the program with RX = OFF is
activated, all the transmitters will be disabled. i.e. stop
transmitters from operating the shutter.
RX = On
From the time when program with RX = ON is
activated all the transmitters will be enabled.
Open Door
From the time when the program with OPEN DOOR is
activated the shutter will open and stay open.
Stop Door
This feature will let the User activate the stop function
until the next program starts. The shutter will not open
or close while stop is activated.
Free Door
Release the controls from the timer.
Off
This will temporarily disable the program.
NOTE: The most recent program that applies to an
output remains active until a new program takes
effect.
NOTE: If a Time Clock program does not have a day
selected then it can not be executed. If a Time Clock
program is taking control of the opener, then this
status is displayed on the LCD. The MAIN SCREEN
and clock status screen fl ashes alternatively.
Menu 7.3 Settings
Under this menu, three sub menus are available:
Run Programs
The programs of the timer can be interrupted by
selecting RUN PROGRAM off.
Confi guration Of GPI Input
General Purpose Input can be confi gured as OSC,
PED or DST setup. This is activated by the GPI input
terminal with the N/O switch.
When GPI Selected As OSC:
If the shutter is moving the activation of the GPI input
or pressing a transmitter button with the OSC function
assigned will cause the shutter to stop. The next
trigger will move the shutter in the opposite direction
to the direction last travelled.
1.
2.
Time Clock
When GPI Input Is Confi gured As PED:
The activation of the GPI input or by pressing a
transmitter button with PED function assigned
will open the shutter partially to allow pedestrian
access but prevent vehicle access. The position
the shutter is driven to is automatically set to
halfway during setting of the travel limits but can
be adjusted to suit.
When GPI Input Is Confi gured As DST:
GPI input can be used to switch between STD
time and DST (daylight savings time). The AUX
input needs to be constantly active to show day
light saving time.
Day Light Saving Time Adjustment
The time selected is the amount of time added
to STD time when DST is selected by AUX input.
Options are OFF, 30, 60, 90 or 120 minutes.
3.
