Owner Installation Instructions
GDO-7v2 SecuraLift®
7
Overload indicator
When the maximum opening and closing capacity of the SecuraLift® is exceeded
the red and green Limits LEDs fl ash alternately to indicate that an overload has
occurred.
Auto courtesy light
The SecuraLift® courtesy light comes on automatically whenever the door is
activated. The light can also be switched on and off without operating the door
by coding a dedicated button on a TrioCode™ transmitter. The light will stay on
for approximately three minutes then switch off. This time is adjustable.
Vacation mode
A hand held transmitter can be programmed to lock and unlock all other
transmitters that have been programmed into the openers’ memory. The vacation
mode can be used when the door is left idle for long periods of time.
Pet/Pedestrian mode
The hand held transmitter can be programmed to open the door partially so that the
family pet can enter and exit the garage at any time. You may also wish to open the
door to a height suitable only for pedestrian access. The door opening position is also
programmable.
Auto-close mode
The opener can be programmed to automatically close after an open cycle. The auto-close time
is adjustable. It is compulsory to install a P.E. Beam if this mode is selected, otherwise the door may
cause personal injury or damage to property.
Photo Electric (P.E.) Beam (optional)
The opener has an input for a P.E. beam to be connected for extra safety protection and use of the auto-close
mode.
Manual operation
The opener is equipped with a unique manual disengaging device. If the power to the opener is disrupted for
any reason the door can be put into manual mode by pulling down on the string handle on an angle towards
the door. This will allow you to manually open or close the door. To re-engage the opener pull the string