GDO-12 HIRO Installation Manual
13
6.7 Coding Transmitter
6.7.1 Transmitter Button to Operate Door
The
GDO-12 HiRo
TM
can store up to sixty four (64) transmitters
in its memory.
a. Press the MODE button to highlight the CODE LED.
b. Press OPEN or CLOSE buton until BLUE CLOSE, RED STOP/
SET and GREEN OPEN LEDs are on.
c. Press and hold the STOP / SET button to enter the code set
procedure
(Fig. 6.7.1)
.
d. Press the transmitter button you wish to use to operate the
door opener (e.g. button 1) and hold for 2 seconds then
release.
e. Press the same transmitter button again and hold for seconds,
then release.
f. Release the STOP / SET button.
6.7.2 Erasing Programmed Codes
If the GREEN OPEN button is held down on power up it will clear
the the transmitter memory. (As the button is being held the
CODE LED will flash).
Fig 6.7.1
If a transmitter is already coded into the opener, additional
transmitters can be coded without being in direct contact with
the opener’s wall console unit.
NOTE:
Only the function of the existing transmitter button can
be assigned to new transmitter. Please read instructions prior to
proceeding - there is a time-out facility for security reasons.
6.7.3 Selecting The Function To Be Coded
a. Using the existing transmitter, operate the Door with the
transmitter button which has the function to be coded (e.g.
Button 1 has been coded with the OSC function assigned).
b. If the button’s function activates the Door (PART, OSC, CLS,
STP or OPN) wait for the Door to complete its cycle.
6.7.4 Activate Remote Code Set Mode
a. Use a small pin / pen to press and hold through the Coding
Hole of the existing transmitter for 2 seconds
(Fig. 6.7.2).
b. Within 10 seconds, press the button on the new transmitter
you wish to code for 2 seconds
.
c. Press the same button again (within 10 seconds) for
confirmation.
d. Test Operation. The new transmitter button should now
function as the existing transmitter.
NOTE:
To code other buttons from an existing transmitter, repeat
process pressing the button your wish to replicate.
Existing
transmitter
Fig 6.7.2
MODE
Button 1
CODE LED
HELPFUL TIP:
Refer to Appendix for Additional
Transmitter coding functions
tip