GDO-12 Wiring and Installation Instructions
Safety Beam Kits
WPE-2V1 KIT -
SAP# ORDER NO. 86802
ITEM DESCRIPTION
QTY
1
WPB-04.02 TX ASSEMBLY
1
2
WPB-04.02 RX ASSEMBLY
1
3
BASE STATION WPE2V1 ASSEMBLY
1
4
MOUNTING KIT
1
FLUSH MOUNTING KIT -
5
PEB4-W1 BRACKET
2
6
TAPTITE SCREW “P” M3 X 8
8
7
SELF TAPPING SCREW M6 X 25
4
8
PLASTIC WALL PLUG 6.7 X 25
4
9
TAPTITE SCREW “P” BLACK ZINC M3 X 12
8
Wireless WPE-2v1
Important Safety Instructions
WARNING!
•
When using Safety beams, the doorway must be clear of all obstructions and persons
a all times. The location of the beams and manner in which they are installed might not
give safety protection at all times.
•
The sensors need to be 100mm above the floor level, however, the exact position must
be chosen in such a manner that it suits the application, the environmental conditions
and provides maximum safety protection.
•
When using auto close mode, a Safety beam must be fitted correctly and tested for
operation at regular intervals. Extreme caution is recommended when using auto close
mode. All safety rules must be followed.
ELECTROCUTION!
•
Disconnect the power cord from mains power and battery backup (if installed) before
making any repairs or removing covers on openers.
CAUTION:
Fall from ladder
•
Ensure ladder is the correct type for job.
•
Ensure ladder is on flat ground.
•
Ensure user has 3 points of contact while on ladder.
Entrapment
•
Ensure the garage door is in good working order by undertaking regular servicing.
•
Safety beams must be installed if the closing force at the bottom edge of the door exceeds
400N (40kg)
Doc # 160097_01
Part # 86806
Released 04/06/19
MOUNTING KIT
ITEM DESCRIPTION
QTY
1
PE 2000TS BRACKET
2
2
ADJUSTMENT BRACKET
2
3
MOUNTING BRACKET
2
4
TAPTITE SCREW “B” PH M3 X 5 ZNC
8
5
PAN HEAD SCREW W/WASHER M5 X 10
4
4
1
5
2
3
5
Right side
bracket
WARNING!
When using PE Beams, the doorway must be
clear of all obstructions and persons at all times. The location
of the beams and manner in which it is installed might not
give safety protection at all times. Check to make sure
that the height of the beam and type used give maximum
protection possible.
WARNING!
PE beams must be installed
if the closing force at the bottom edge
of the door exceeds 400N (40kg force)
EASYBEAM P.E.-3V1 KIT
SAP# ORDER NO. 62626
ITEM DESCRIPTION
QTY
14
EASYBEAM RX-TX SET
1
4
MOUNTING KIT
1
EasyBeam
TM
PE-3v1
