© March 2019 Automatic Technology (Australia) Pty Ltd. All rights
reserved. No part of this document may be reproduced without prior
permission. In an ongoing commitment to product quality we reserve
the right to change specification without notice. E&OE.
Troubleshooting
Symptom
Possible cause
Remedy
Base station and receiver LED’s constantly on
Receiver is not coded into base station
Code the receiver into base station
Receiver LED constantly on but cannot close
the door
Receiver not coded into base station
Mains power is not switched on to the opener
Code the receiver into base station.
Switch on mains power
Receiver LED is blinking and can not close
the door
Receiver and transmitters not aligned
properly
Realign receiver and the transmitter
Beam is obstructed
Remove obstruction from the path of the
beam.
During optical alignment transmitter LED
stopped working
Setup timed out
Press reset button on the transmitter.
During optical alignment receiver LED
stopped working
Setup timed out
Press reset button on the base station.
Wireless PE beam works ok but LED’s on
receiver and transmitter stopped working
To save battery power LED on transmitter
turns off after number of cycles
No remedy required.
LED on the receiver/transmitter started to
flash during operation of the door
The battery in the receiver/transmitter is
getting flat
Replace the batteries.
Specifications
Maintenance
To ensure a long and trouble free life for your Safety Beams, the following is recommended:
a. Periodically test the Safety Beam is operating efficiently by obstructing either the transmitter or receiver during the openers
operation to ensure the door stops.
b. If the Safety Beams are located in a very dusty / dirty environment make sure to clean transmitter and receiver lenses for
optimal performance.
c. Replace batteries in transmitter or receiver (Wireless WPE-2V1 only) when they start to flash during operation of the door.
Warranty
WPE-2V1 & PE-3V1
ACCESSORIES
1 year
This warranty is to be read in conjunction with the owner’s copy of the opener installation instruction.
Technical Specifications
EasyBeam
TM
Wireless
Infrared beam range
20m
6m
RF link range
-
10m
RF link frequency
-
2.4 Ghz ISM Band
Batteries for Wireless RX and TX
-
C-Type x 2
Battery Life
-
3 years approx.