KPX-7V2
Wireless Keypad
1.1 Coding KPX into the Opener
The Opener can only operate from keypads that have been programmed into its receiver. The receiver needs to learn the codes of any
keypad / transmitter that will be used by the operator.
a. Decide which Channel button (eg. 1 = Garage Door) is to be used to operate your garage door.
b. Code the Channel button to the operator’s receiver by pressing and holding the Door Code button on the Opener, then select your
Channel button and hold for 2 seconds.
c. Release the Channel button and pause for 2 seconds.
d. Select the same Channel button and hold for 2 seconds.
e. Release both the Channel button and the Door Code button.
NOTE:
If more than one device is to be controlled (for example: garage door and sliding gate) then repeat this step for each Channel
button to be used (record the channel function in the table on the back page of this instruction).
1. Quick Set up Guide
There are 8 Channel buttons (keypad no. 1 - 8) in the KPX-7V2 to store functions and these can be programmed for
example (1 = Garage Door, 2 = Automatic Gate, 3 = Outside light)
If only a single User Pin and one channel function (Garage Door) is required, proceed to the Quick Set Up Guide.
Alternatively for multiple User Pins and / or mulitple receivers, follow the Quick Set Up Guide and then proceed to
Sections 2 and 3.
Getting Started
1.2 Program Primary User
Select a PIN code (4 - 8 digits) to be used to operate the keypad and save it using the
following steps (or below Short cut Guide):
a. Press and hold the FCN button. The Keypad will beep and flash to indicate it is in
learning mode. Release button.
b. Enter in your new 4 digit User Pin Code and press FCN button.
c. Re-enter the same 4 digit User Pin Code and press the FCN button.
d. The Keypad will beep and flash to indicate it is exiting learning mode.
WARNING! Record the Primary User PIN Code. If this PIN Code is
lost / forgotten the unit has to be sent back to the factory to be
reset
.
Short cut Guide - Program Primary User
Open out for more functions and features
1.3 Test the Operation of the Keypad
Test operation by entering the User Pin Code followed by selecting a
programmed Channel button.
NOTE:
Hold the selected Channel button until the channels function activates.
NOTE:
by pressing another Channel button (and holding) within 10 seconds
from releasing the first Channel button, will activate the second Channel
function (eg. 3 = Outside light) without having to re-enter the User Pin Code.
1.4 Change User Pin
To change the User Pin, simply enter the User Pin, then follow step 1.2a - d.
Short cut Guide - Change User Pin
BEEP
FCN
HOLD
USER 1 PIN
(4 - 8 digits)
FCN
FCN
FLASHES
USER 1 PIN
BEEP
FLASHES
USER PIN
BEEP
FLASHES
NEW
PIN
FCN
NEW
PIN
FCN
BEEP
FLASHES
FCN
HOLD
