Owner Installation Instructions
NeoSlider
TM
- Sliding Gate Opener NES-500 / NES-800
3
WARNING!
• The gate may operate unexpectedly, therefore do not allow anything to stay in the
path of the gate.
• Do not disengage the gate opener to manual operation with children/persons or any
objects including motor vehicles within the gateway.
• Remove or disengage all gate locks and mechanisms prior to installation of the
opener.
• Make sure the gate is fully open before driving into or out of the driveway.
• When using auto close mode, a
Photo Electric beam
must be fitted correctly and
tested for operation at regular intervals.
Extreme caution
is recommended when
using auto close mode.
All safety rules
must be followed.
ELECTROCUTION!
• Do not immerse in or spray the NeoSlider with water .
• Disconnect the power cord
from mains power before making any repairs or
removing covers. Only
experienced
service personnel should remove covers from
the gate opener.
• If the power supply cord is damaged, it
must
be replaced by an Automatic Technology
service agent or suitably qualified person.
• Connect the gate opener to a properly
earthed
general purpose 240V mains power
outlet installed by a qualified electrical contractor.
CAUTION:
Entrapment from
operating gate
• DO NOT
operate the gate opener unless the gate is in full view and free from objects
such as cars and children/people. Make sure that the gate has finished moving before
entering or leaving the driveway.
• Do not allow children to play with gate controls or transmitters.
• In order for the NeoSlider
TM
to
sense
an object obstructing the gateway, some
force
must be exerted on the object. As a result the object, gate and/or person may suffer
damage
or
injury.
• Regularly check to make sure that the
Safety Obstruction Force
is working correctly,
and is
tested
and set as per
Section 12 of this manual
. Failure to follow these
instructions could result in
serious personal injury
and/or property damage. This
test must be repeated at regular intervals and the necessary adjustments made as
required.
• If using a key switch, keypad or any device that can operate the gate opener, make sure
it is in a location where the gateway is visible, but out of the reach of children at a
height of at least 1.5m.
• For
ADDITIONAL SAFETY
protection we
STRONGLY
recommend the fitting of a
Photo Electric (Safety) Beam. In most countries Safety Beams are mandatory on all
gates fitted with automatic openers.
Installation
• Ensure the gate(s) is in good working order . Faulty gates must be repaired by a qualified
technician prior to NeoSlider
TM
installation.
Security
• Make sure that the gate is fully closed before leaving the driveway.
Entanglement in
or laceration from
moving gate
• Keep hands and loose clothing clear of gate at all times
• Keep clear of gate during operation as severe lacerations can occur on sharp edges of
gate.
1. Important Safety Instructions
The safety alert symbols below indicate a personal safety or property
damage instruction exists. READ THESE INSTRUCTIONS CAREFULLY.
This NeoSlider
TM
Sliding Gate Opener is designed and tested to offer safe service
provided it is installed and operated in strict accordance with the following safety rules.
Failure to comply with the following instructions may result in death, serious personal
injury or property damage.
