April 28
th
, 2020
Page 17 of 49
System Setup
The system setup is divided into 2 steps. We recommend doing the installation with 2
persons.
Step 1: Blackbody and infrared camera
Both components are equipped with threaded holes or mounting plates to allow safe
and stable integration into existing building entrances or general passageways.
Detailed information on the mechanical dimensions and mounting options can be
found in the technical drawings in the appendix.
Infrared Camera
The power supply unit for the infrared camera is provided by the supplied I/O panel. First
install it in a switch box where it is protected against unauthorized or accidental contact.
Connect the supplied power supply unit to the respective connections of the panel. The
pin assignment can be found in the following table.
Power supply
I/O panel
24 VDC+
+
24 VDC-
-
Now use the M12 power/IO cable to establish a connection between the I/O panel
connection and the corresponding connection on the back of the camera.
Connect a computer system to the infrared camera via the M12-RJ45 network cable.
Blackbody
The power supply and control of the blackbody is provided by the control unit. To do this,
install the switch box of the control unit near the blackbody and connect the grey cable
of the control unit to the cable socket provided for this purpose.
Power supply and I/O 17 pin
M12 round connector
Network cable (green) with 8 pin M12 round
connector
Summary of Contents for FebriScan
