12
We strongly advise the activation of the Manual stop switch during any
maintenance of or around your Turbine. This will prevent the blades from
spinning and voltage to be transferred. Likewise, during initial installation
please activate the Manual brake. In the final step in the installation of the
Turbine, manual stop switch should be released.
The Manual stop switch is pre-wired for your convenience, place the
corresponding wires (Red, Black, Blue) from the Manual stop switch into
the MPPT input terminals. They should be connected corresponding to the
color code from your Turbine. Turbine and manual stop switch share input
terminals on the MPPT, this provides a parallel connection.
Test the connection of your Manual stop switch at the point of initial
installation. Push the brake “ON”. You should see the Turbine stop its rotation.
Continue to apply this brake during the remainder of your installation.
Should the Turbine continue to spin, check your terminal connections?
Do
not approach the Turbine without activation of this Manual stop switch
under any circumstance!
• It is strongly advised to test both the manual stop switch and MPPT prio-
dically.
• The Manual stop switch is pre-wired, this should not be altered.
• The manual stop switch should be placed close to your MPPT in a dry venti-
lated environment.
• For multiple turbine applications please use an individual Manual stop swi-
tch and MPPT controller for each wind turbine.
• This manual stop switch has been designed specifically for your wind tur-
bine; it should not be incorporated into other models.
