5
H3/8
. GRAY WIRE
– (-) 200mA PROGRAMMABLE OUTPUT –
CHANNEL 2 OUTPUT
(Factory default setting)
This wire will provide a 1 second pulse ground when you press and hold the
button on the transmitter for two seconds. The current capacity of this wire is 200 mA.
This feature allows you to operate remote control trunk release or other electric
devices.
2 STEPS UNLOCK OUTPUT
(Set Feature
B – 3
Programming to “2 Step Door Unlock Output)
The 2 steps unlock feature will work for the most fully electronic door lock circuit. The
vehicle must have an electronic door lock switch, which locks and unlocks all of
vehicle's doors. When wired for this feature, press the
button one time, the alarm
will disarm and unlock the driver's door only. If you press the
button two times
within 3 seconds, the alarm will disarm and unlock all doors.
H4: RF ANTENNA - BLACK THIN WIRE
The black thin wire on the control module is the receiver antenna wire. Antenna placement
is very important! Ensure that it is unwrapped and stretched out with the last 6" straight and
keep it away from large metal objects or chassis for best reception.
H7: 3 PIN DOOR LOCK CONNECTOR:
Blue Wire
Green Wire
(
-
) 200mA Lock Pulse
( + ) 200mA Unlock Pulse
(
-
) 200mA Unlock Pulse
( +) 200mA Lock Pulse
3 Pin Mini - Connector
+12V
Master Door
Lock Switch
X
X
Splice
Splice
Cut the Existing
Lock Wire
To Door
Lock
Motor
To Slave Door
Lock switches
Cut the Existing
Unlock Wire
3 Pin Plug
To Alarm
5-WIRE ALTERNATING DOOR LOCK
30
86
87a
85
87
30
86
87a
85
87
+12V
Green Wire
Blue Wire
