Autopage RF-350 rs, Installation & User Manual

10

/ hood / trunk, the security system LED will stop flashing. It will begin flashing again 
once all vehicle entrances are closed. 

2.  After 30-second timer has elapsed, the security system will automatically “ARM”. The 

siren will chirp [1] time and the parking lights will flash [1] time. 

 
PASSIVE DOOR LOCKING:

The vehicle doors will automatically lock after passive arming cycle has been completed. 

ACTIVE DISARMING – UNLOCK & DISARM: 

1.  Press the 

button on the transmitter. 

2.  The siren will chirp twice and parking lights will flash twice to indicate that the security 

system is now disarmed.  The vehicle doors will unlock and disarm when interfaced 
with the security system. 

TAMPER DISARMING

: If the alarm is triggered; upon disarm the system, the siren will 

chirp 4 times and parking lights will flash 3 times. 

TWO STEP DOOR UNLOCK

: This feature will independently unlock the driver’s door only 

when disarming the security system. Pushing the 

button on the transmitter a second 

time within 3 seconds will unlock the entire vehicle.  

AUTOMATIC RE-ARM

: If this feature is selected, the security system will automatically re-

arm itself 60 seconds after disarming with remote transmitter. Automatic rearm will cancel if 
any door is opened before the 60 seconds timer has elapsed. 

DISARMING WITHOUT A TRANSMITTER 

The Override function may be used if the remote transmitter is lost or inoperative. 
1.  Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm will sound.) 
2.  Within 10 seconds push and release the valet switch The alarm will stop sounding 

and enter the disarm mode. You can now start and operate the vehicle  normally. 

VALET MODE:  

The valet switch allows you to temporarily bypass all alarm function, eliminating the 
need to hand your transmitter to parking attendants or garage mechanics. When the 
system is in valet mode, all alarm functions are bypassed, however, the remote panic 
feature and remote door locks will remain operational.  

Enter Valet Mode: 

1. Turn the ignition to “ON” position. 
2.  Push and hold valet switch for 2 seconds or until the LED turns on. The LED will 

remain on as long as the system is in 'valet mode'. 

  Exit Valet Mode: 

1. Return to normal operation, turn ignition 'ON'. 
2. Push and hold valet switch for 2 seconds; the LED will turn off indicating the system is 

exiting the valet mode. 

 
PANIC FUNCTION:   

The transmitter can be used as a remote panic switch to manually trigger the alarm in 
case of emergency.  

1.  Press and hold the 

button on the transmitter for 3 seconds. The alarm will 

immediately    sound.  

2.  To stop the alarm, press and hold the  

 or

button on the transmitter, the panic 

mode will be turned off immediately. 

3.  If the button is not pressed, the alarm will automatically stop after 30 seconds .