10
H5.2 PIN WHITE CONNECTOR (THE LED STATUS INDICATOR:
The led indicator status should be mounted in a highly visible area such
as top of the dashboard, on top of the shifter console or on dashboard
face. Leave at least 6mm space behind the mounting location for LED
housing. Once a suitable location is chosen, drill a 6mm hole. Run the
LED wires through the hole then press the 2-pin LED housing into the
place. Route the LED wires to the control module.
H3. BLACK 4-PIN CONNECTOR:
WINDSHIELD MOUNT ANTENNA
The RF Antenna/Receiver Red connector is to be plugged in the red
4-pin port on the main unit. The White connector is to be plugged into the
RF Antenna/ Receiver plug. Mount the antenna/receiver with provided
double sided tape to center of windshield above rear view mirror, route
the antenna lead along the windshield pillar under the vehicle’s interior
windshield molding.
H7: 10-PIN MOLEX WHITE CONNECTOR WIRE HARNESS:
ORANGE WIRE –
(-) 500ma GROUNDED OUTPUT WHENARMED —
This wire will become grounded when the alarm is armed. The current
capacity of this wire is 500mA. This output can control starter disable,
when an intrusion is detected and the system is triggered.
87
87a
85
30
86
IN4003 Diode
H5/1
: ORANGE wire
from control module
“Start”
“On”
Violet wire
X
Cut
Yellow wire
White wire
“Acc”
“Off”
Starter
H1/1
VIOLET wire (Starter output)
form Heavy Gauge wire harness
Red wire to
Ignition Switch
YELLOW WIRE: (-) 200ma IGNITION 3 OUTPUT –
This wire provides a 200mA (-) ground output that becomes active 4
seconds before the remote start unit is initialize, and remains grounded
while running.
Ignition 3 output:
Some newer vehicles use a third ignition wire, which is required to start
and keep the vehicle’s engine running. If this is the case, wire an IGN 3
relay (not supplied) as shown below:
Do not connect any vehicle circuits together; they are isolated for a
reason. See diagram next page.
