19
FEATURE PROGRAMMING:
FEATURE “A” PROGRAMMING:
1.
Turn the Ignition ‘switch ‘ON/OFF’ 3 TIMES and stay in OFF
position.
2. Push the Valet switch
3
times (holding in on the 3rd push) until
one
chirp with a long chirp is heard, then release the valet switch. You
are now in the Alarm feature
‘A’
programming mode.
3. Press and release the transmitter button corresponding to the feature
you want to program. (See chart on next page)
4. Depress the transmitter button again to change the feature.
Simply keep re-depressing the transmitter button again until the
module advances to your desired setting.
a. In this case, Press the button again, the module would advance
to [2] LED flash, [2] horn chirp.
b. Press the button again; the module would advance to [3] LED
flash, [3] horn chirps etc.
Exit:
Turn Ignition to ‘ON’ position, or leave it for 15 seconds.
3 long chirps & 3 parking light flashes will confirm exit.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
Pathway
illumination
feature “off:
Parking lights
turn “on for
30-seconds
upon disarm
Parking lights turn
on for 30-seconds
upon disarm & 10
sec. upon arm
2
Brown Wire=
Horn
White Wire=
Dome Light
Gray Wire= 2
nd
Channel
Brown Wire=
Factory
Rearm
White Wire=
Dome Light
Gray Wire=
2
nd
Channel
Brown Wire=
Horn
White Wire=
Factory Rearm
Gray Wire= 2
nd
Channel
Brown Wire=
Horn
White Wire=
Dome Light
Gray Wire=
Factory Rearm
3
Pink Wire=
2 Step Unlock
Pink Wire=
Factory Disarm
Pink Wire=
Sensor by-pass
Pink Wire=
Sensor by-pass
20sec
4
Confirmation
Chirps
“ON”
Confirmation
Chirps
“Off”
5
+
Lock/Arm &
Unlock/Disarm
Confirmation
Chirps
Lock/Arm
Confirmation
Chirp Only