22
START FEATURE “D” PROGRAMMING:
1. Turn the Ignition ‘switch ‘ON/OFF’ 3 TIMES and stay in OFF
position.
2. Push the Valet switch
9
times (holding in on the 9TH push) until
four
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature
‘D’
programming mode.
3. Press and release the transmitter button corresponding to the feature
you want to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three
pulse
Four Chirps /
LED four pulse
1
Exit the programming mode.
(3 long chirp & 3 parking light flashes to confirm this exit.)
2
+
Tachometer
Check type (3A)
Voltage check
type (go to 3B)
Timer checking
type (go to 3B)
A> RPM learning – see RPM Learning page ##.
3
B>
Start Crank Time:
0.6-second
0.8-second (2 chirps), 1.0-second (3 chirps),
1.2-second (4 chirps), 1.4-second (5 chirps),
1.6-second (6 chirps), 1.8-second (7 chirps),
2.0-second (8 chirps), 3.0-second (9 chirps),
4.0-second (10 chirps),
4
Low check level
Hi check level
5
Start or Stop the system for TESTING & ADJUSTMENT
Exit:
Press the
button on the transmitter. 3 long chirps & 3 parking
light flashes will confirm exit.
TACHOMETER CHECKING TYPE:
Enter Start Feature ‘D’
Programming Mode:
1. Turn the Ignition ‘switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch
9
times (holding in on the 8th push) until
four
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature
‘D’
programming mode.
Select “Checking Type”:
3. Press and release the transmitter
+
button once to set the
“Tachometer Checking Type”. [1] LED flash, [1] Horn chirp to confirm
this setting.
4. Once you complete step 3, you can program “RPM Learning Mode” as
follows:
