26
RETURN TO FACTORY DEFAULT SETTING:
1. Turn the ignition ON then OFF 3 TIMES and stay in OFF position.
2. Push the Valet switch
12
times (holding in on the 12th push) until
Six
chirps with a long chirp is heard then release the valet switch. You are
now in the “Return To Factory Default Setting” programming mode.
3. Press the
+
button on the transmitter together for 6 seconds,
there will be a confirmation six chirp with 3 long chirp and parking
light flash 3 times to confirming the system “Alarm Feature A & B
Programming“ all returns to factory default setting.
RETURN TO START FEATURE FACTORY DEFAULT SETTING:
4.
Press the
button first within 3 seconds, then press the
+
button on the transmitter together for 6 seconds, there will be a
confirmation six chirp with 3 long chirp and parking light flash 3 times
to confirming the system “Start Feature C & D Programming all
returns to factory default setting.
SHUT DOWN DIAGNOSTICS:
The unit has the ability to report the cause of the last shutdown of the
remote start system.
Enter:
1. Turn the Ignition ‘switch to ‘ON position.
2. Press the
button on the transmitter.
3. The LED will now report the last system shutdown by flashing for one
minute in the following grouped patterns:
LED
Flashes
Shutdown Mode
1
(-) Safety Shutdown input
(Hood)
1. Close the hood.
2. Check H
7
/1 White/ Black wire
connection.
2
(+) Safety Shutdown input
(Brake) or
Neutral Safety Switch input
fail.
1. Check H
7
/2 White/ Violet wire
connection.
2. Move the Enable Toggle Switch to
“ON” position. (If installed.)
3. Move the gear selector to “Park”/
“NEUTRAL” position.
4. Check H
7
/3 Black/White wire
connection.
3
No RPM or
Low Voltage.
Tachometer Checking Type
:
Check H
7/5
White/Red wire connection
Voltage Checking Type
:
Program the “CHECK LEVEL” from
“Hi Check Level” to “Low Check Level”
