SmartPot 80 System
setup instructions
Using your front instruction sheet, repeat the module set up instructions for the number of trays.
If you require any guidance
email - mail@autopot.co.uk
Advice
Allow your plants to establish for 7-10 days before turning system on
mail@autopot.co.uk I www.autopot.co.uk I +44 (0)844 8581520
Plan views
and options
Suggested layouts
• 1x 750 ltr FlexiTank
• 80x 1Pot XL tray and lid
• 80x 18.9 ltr SmartPot
• 80x AQUAvalve
• 1x 16mm tank adapter and filter
• 4x 16mm in-line tap
• 40x 16 - 6mm cross connector
• 3x 16mm tee connector
• 30 metres of 16mm pipe
• 40 metres of 6mm pipe
• 80x PotSock Round
SmartPot 80 System contents
SmartPot 80 dimensions
Advice
• Please note that multiple SmartPots may increase room hummidity due to the exposed surfaces of the fabric pots.
• Pot up your plants, water through, then allow your plants to establish in the pots for a period of 7 to 10 days before
turning your system on. This will encourage a stronger and healthier root system.
• Always raise your tank to a minimum of 150mm above the highest AQUAvalve and re-fill the tank when there is
approximately a 1/3 of the solution left - NEVER ALLOW THE TANK TO RUN EMPTY.
• For best results, we recommend mineral fertilisers. Do not use organic fertilisers, as they have a tendency to block
small pipe work.
• Clean all substrate from the bottom and sides of the pots before placing in each tray. This will ensure your system is
clean from the start.
• Always use free draining substrates, for example: soil/perlite, coco/perlite, soil/clay pebbles, coco/clay pebbles,
rockwool/clay pebbles.
1
8
2
Fit the PotSock Round
over the base of
each SmartPot
5
Position tray so it is
level.
3
Remove collar.
Push 6mm pipe through
collar and attach to
AQUAvalve nozzle.
Rescrew collar -
DON’T
overturn...
when you feel
it grip
STOP.
Connect AQUAvalve
so ‘half moon’ is on
T section in the tray.
4
Fill SmartPot with
medium and pot
up plants.
Water through pot
and allow to drain
outside the tray.
Place SmartPot in the
tray, make sure it is
CLEAN!
Place lid over valve
onto tray.
Cut 6mm/16mm pipe
to appropriate length
6
380mm
285mm
280mm
355mm
18.9 ltr
pot
System requires minimum
750 litre FlexiTank (supplied)
750 ltr
FlexiTank
900mm
1200mm
7
According to the size of your system connect your
6mm/16mm pipe to relevant fitting or tank...
6mm pipe
16mm pipe
AQUAvalve
16mm click-fit tank adaptor & filter
16mm in-line tap
16mm tee connector
16mm – 6mm cross connector
750 ltr
FlexiTank
Elevate tank
150mm from
floor to maintain
gravity pressure
6mm pipe
16mm pipe
AQUAvalve
16mm click-fit tank adaptor & filter
16mm in-line tap
16mm tee connector
16mm – 6mm cross connector
750 ltr
FlexiTank
Elevate tank
150mm from
floor to maintain
gravity pressure
