AS-1412
Installation Guide
P. 7
Ignition barrel).
Option 4 (Smart Ignition Re-Lock):
Connects to the
Negative Door trigger Input.
When the Ignition Lock
Option or the Lock Only Option is enabled: after the
Brake Pedal is pressed and after a Door has been
opened and closed, the Doors will
RE-LOCK
.
10
WHITE
(–) Ground Out
When Running
This is a 500-mA constant ground output active when
the vehicle is running under a remote start. The output
becomes active at the same time as Ignition and
becomes inactive when the Module shuts down (i.e.: run
time has expired or button
,,
is pressed, etc.). The
output can be used to activate external relays, bypass
kits, etc.
CAUTION!
If multiple relays or modules are connected
to the Ground Out wire, ensure that they are all diode
isolated in order to avoid feedback and damaging the
vehicle.
11
GRAY
N/A
This pin is not used – leave empty.
12
YELLOW
(+) Glow-plug
input
This positive input will monitor the Glow Plug Light in
Diesel Mode: it will wait until the Glow Plug Light goes
out to crank the Engine. Connect to the side of the Glow
Plug Light that is positive when the Light is on.
Note
: In Diesel Mode there is a 18-sec. crank timing
delay (or approximately 25-sec. if the run time is set to
30 min.): if the Glow Plug Light is still on after the delay
expires, the Module will proceed to start the Engine
.
(Also known as the “wait-to-start light”.) The purpose of
the Glow-plug circuit on diesel vehicles is to pre-heat
the Combustion Chamber before the vehicle is started.
When a Remote Starter is installed on a diesel vehicle,
the Glow- plug section of the Ignition circuit must be
activated and allowed to operate before the vehicle is
remote-started. For that purpose, the Glow-plug input
wire of the Module must be connected to the Glow-plug
indicator light of the vehicle. The Module will only accept
positive Glow-plug input signals, if the signal is negative,
use a relay to invert its polarity. A diode must be added
between the negative Glow-plug trigger on the relay and
the negative Glow-plug wire of the car. This is to prevent
feedback effects on the Glow-plug indicator light on the
instrument cluster: the light on the dash would come on
because of the feedback, even though the circuit is off.
When the user remote-starts the vehicle:
The Module will power up the Ignition circuit and wait to
engage the Starter Motor while the Glow-plug indicator
light is still on.
The Module will engage the Starter Motor as soon as
the Glow-plug light (+) goes out.
x
Minimum waiting
time is 3 seconds.
x
Maximum waiting
time is 25 seconds (approx).
If no Glow-plug wire is found on the vehicle, the Glow
