Autostart AS-1414, Installation Manual

AS-1414/ AS-1424

 Installation Guide  

P. 11

OPTION 3 

DIESEL

 Engine Mode  

FUNCTION 4 – AUX 1 programming 

OPTION 1 

Priority door access 

OPTION 2* 

Horn confirmation on 2

nd

 press of

 LOCK 

button

OPTION 3 

Horn confirmation when pressing 

LOCK 

button 

Auto Tach Programming Procedure 

NOTE:  

If no tach has been programmed and the 

START

 button is pressed, there will be 

no start attempt and the vehicle will give 5 flashes. If another tach programming is 
required, simply repeat the auto tach programming procedures.  The module stores the 
tach setting, being 

autotach

 or multi-speed tach, until the module is reset.  

ONLY

 if the 

module is reset will a new tach signal need to be re-programmed. 

This process can be carried out instead of the conventional tach programming procedure.  

1.

Make sure all the connections are done properly and that the module has been 
powered-up. 

2.

With the hood up (ground on the hood pin line), start the vehicle using the key. 

3.

Let the engine reach proper idle speed 

The parking light output from the module is activated when the vehicle starts and it 
will shut off once the tach signal is detected. 

4.

Press and hold the brake pedal until the parking light output from the module flashes 
5 times.  

5.

Turn the ignition OFF.  At this point, the tach setting has been programmed. 

Table 4 

Multi-Speed Tach Programming  

The system is designed to read a wide range of tach signals produced by newer ignition 
systems. No manual adjustments are necessary. However, you should go through the tach 
programming procedure every time a new unit is installed. 

1.

FLASH 

the hood pin switch.

Before the 20 seconds have passed.

2.

Press and hold the brake pedal.

Press the 

LOCK

and 

UNLOCK

 buttons simultaneously on the transmitter. 

The parking lights will flash 4 times. 
Release the brake pedal. 

3.

Start the vehicle and let it to reach regular engine-idle speed. 

4. 

Once the vehicle is idling properly, press and hold the brake pedal until the parking 
lights flash five times, release the brake pedal: the tach signal is now programmed.

Table 5 

Horn Chirp Timing  

Follow these steps to program horn confirmation: 

1.

Flash the hood pin. 

The Parking Lights will stay on for up to 20 seconds

.

2.

Press and hold the brake pedal, then simultaneously press the 

UNLOCK

and 

START 

buttons on the transmitter – the horn will honk 5 times. 

3.

Release the brake pedal. 

4.

To change the timing: