P. 6
Installation
Guide
AS-1414/ AS-1424
wire before remote start.
6
BLUE / WHITE
(–) AUX 1
500 mA ground output on the 2
nd
consecutive press of
the
UNLOCK
button for priority door access, or a horn
confirmation on the first or second press of the
LOCK
button –depending on the option that was selected in
the programming menu (see page 11).
7
WHITE /
ORANGE
(–) Starter Kill
(Armed output)
The unit is equipped with a selectable
passive-
or
active-arming Starter Kill
circuit that will immobilize
the vehicle when the system is armed. This wire will
provide a constant 500-mA negative output when the
system is
armed
(locked by remote) or if remote started.
This wire should be connected to a Single Pole Double-
Throw Relay (This wire will connect to Pin 85, on the
relay, and Pin 86 will be connected to the Ignition wire).
A second benefit of the starter kill is the anti-grind
feature: When the vehicle has been remote started the
anti-grind prevents the starter motor from re-engaging
when the ignition key is inserted in the ignition switch
and accidentally turned to the
CRANK
position (The
starter kill output becomes active during remote starts).
8 ORANGE
(–) Parking
Light output
Negative parking light output.
9 PURPLE
(–) External
Trigger input
The external trigger wire can be used for remote-starting
the vehicle with an external device. When the vehicle is
running, triggering this input will activate idle mode. The
external trigger wire can also be used to operate as a
negative trigger with the trunk pin switch, the key sense
wire or the door pin switch:
Option 1 Connects to negative trunk pin.
When this
wire is programmed for
TRUNK PIN
, pressing
TRUNK
will
activate a 1-second disarm output. If ground (-) is
detected on the trunk pin (the trunk has been opened),
an arm pulse will be sent 5 seconds after the trunk is
closes. An arm pulse will be sent 4 seconds after the
TRUNK
button is pressed if the trunk pin state is
unchanged (The trunk was unopened). A disarm pulse
is sent only if the system was previously locked and
armed. If
Secure Lock
is enabled
,
UNLOCK
pulse(s) will
be sent with the disarm pulse, a
LOCK
pulse and a rearm
pulse will be sent when the trunk is closed or if the trunk
was left closed
.
Option 2 (Default: Engine Start/Stop):
The first
ground (-) pulse on this input will start the engine, the
second ground (-) pulse on this input will stop the
engine.
Option 3 (Key Sense (-) Input):
Connects to OEM key
sense wire.
When the key is detected in the ignition
switch (ground (-) signal on the OEM key sense wire)
the starter kill will not arm even when it is set to passive
