Multi-car Operation
This options allows the owner of two vehicles, both equipped with the same Module, to control the 2
systems with only one remote transmitter. To control the 2nd vehicle, simultaneously press the
TRUNK
button and the button of the function you wish to use:
x
Press TRUNK + LOCK button simultaneously: LOCK
x
Press TRUNK + UNLOCK:
UNLOCK
x
Press TRUNK + START/STOP:
START
x
Press TRUNK + START/STOP:
STOP
x
Press TRUNK + LOCK + UNLOCK:
TRUNK
Starter Kill Option
This added security feature will immobilize your vehicle when the system is armed. If your Autostart was
installed with the Starter Kill option, you will not be able to start your vehicle with the key unless the
system has been disarmed first.
The Starter Kill option can be programmed to be
ACTIVE
(will not arm automatically) or
PASSIVE
(will arm
automatically). In
PASSIVE
Mode, you can program it to arm automatically in 1 or 3 minutes.
To
disarm
the Starter Kill option in
ACTIVE
or
PASSIVE
Mode, press and hold the
UNLOCK
button on the
transmitter. The parking lights will flash twice. (If door locks were installed, this will also unlock the
doors). In
PASSIVE
Mode, the system will automatically re-arm itself 1 or 3 minutes after unlocking the
doors, if the key has not yet been inserted in the ignition.
To
arm
the Starter Kill option in
ACTIVE
or
PASSIVE
Mode, press and hold the
LOCK
button on the
transmitter. The parking lights will flash once. (If the door locks were installed, this will also lock the
doors
Diagnostics - Parking Lights Flash Rate
FLASHES
DESCRIPTION
1
Doors locked
End of run time
Run time cancelled
Trunk opened
Cancelled cold weather
Or cannot start after maximum attempts of tries
2
Doors unlocked.
3
Entering Cold Weather Mode
Tach watch lockout.
4
+12 volts where detected on the Brake line and cancelled cranking
5
New transmitter learnt
Tach learnt
6
Remote start attempt was made with a Tach or a vacuum signal detected
8
Unit Reset: Occurs when the unit is reset to factory default
10
The Hood line went to ground during crank or run time
3 + 4
The vehicle went out of Ready Mode; +12 V detected on the Brake Line, remote start
disabled.
3 + 10
The vehicle went out of Ready Mode; Hood Switch input went to ground.
ON 4 sec.
The Hood opened and the Hood Switch line went to ground. This is step one of the
programming modes.
ON 5 sec.
The end stage of the procedure to program transmitters.
ON 20 sec.
If the Hood Switch is flashed two times (down-up- down-up), the unit went into step 1 of the
programming cycle and no transmitter activity was detected for 20 seconds.
IRREGULAR
If the unit flashes erratically, it is in playback mode. This occurs when the Hood Switch line is
flashed three times (down-up-down-up- down-up).
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
AS-1415 CF
User Guide
page
4
