Autostart AS-2360TW, Installation Manual

P. 20

Installation 

Guide

 AS-2360TW

If order to carry out Tach Programming, you may simply follow the Automatic Tach 

Programming procedure.  
The Remote Car Starter stores Tach settings regardless of the procedure used at the 

time of Tach programming. All Tach settings are cleared when the Remote Car Starter is 

reset. A new Tach Programming procedure has to be carried out 

only

 if the Remote Car 

Starter is reset. 

Multi-speed Tach Programming 

Tach signals may vary from vehicle to vehicle. The

Remote Car Starter is designed to 

read a wide range of Tach signals produced by recent Ignition systems. There is no 

necessary manual adjustment. Nevertheless, a Tach-programming procedure 

must 

be 

carried out 

every time a new Remote Car Starter Unit is installed

. This is because the 

Tach signals of certain Ignition systems are sometimes too low or too high for the 

Remote Car Starter, causing failed start-ups at various temperatures. 

1.

Flash the Hood Pin switch (see Table 1)

– The Parking Lights will stay 

ON

 for up to 20 seconds.  

– Before the lights go out:

2.

Press and hold the 

Brake Pedal

, 

   – And simultaneously press the 

LOCK

 and 

UNLOCK

 buttons on the Transmitter: 

– The Parking Lights will flash 4 times. 

– Release the Brake Pedal. 

3.

Start up the Engine 

and allow the vehicle to reach regular Engine idle speed. 

4.

Once the Engine is running idle, press the 

Brake Pedal 

and keep it down until you 

hear the Parking Lights Output flash 5 times. 

– Release the Brake Pedal: Tach Programming is now complete. 

Table 7 

Note 

The L.E.D. follows the Parking Lights during the 
Transmitter Programming procedure. 
At any time, close the Hood to end the Tach-
programming procedure. 

Automatic Tach Programming 

This simple procedure can replace the Multi-speed Tach Programming procedure: 

1.

Make sure that all the connections are properly made and that the Remote Car 
Starter is powered up. 

2.

With the Hood up (ground on the Hood Pin switch line), start the vehicle using the 
Key. 

3.

Allow the vehicle to reach regular Engine idle speed. 

The Parking Light output from the Remote Car Starter will activate when the 
vehicle starts and shut off once a Tach signal is detected. 

4.

Press the 

Brake Pedal 

and keep it down until you hear the Parking Lights Output 

flash 5 times. 

5.

Shut down the Engine. Tach Programming is now complete. 

Table 8