Autostart AS-2360TW, Installation Manual

P. 26

Installation 

Guide

 AS-2360TW

If option 

Ignition Unlock Only 

is selected, the system will 

UNLOCK

 all Doors when the key 

is turned to the 

OFF

 position (provided that the Ignition key was in the 

IGNITION ON (RUN)

position and that the Brake Pedal was pressed at least once). 

Secure Lock 

This feature allows the Remote Car Starter to control certain OEM factory Alarm systems 

without requiring the use of other wires for disarming the OEM Alarm. (Namely, this 

feature is designed for OEM systems which use the factory Lock wire to 

arm 

the Alarm 

and the Unlock wire to 

disarm 

it.) 

Standard Secure Lock 

If this Option is selected, upon receiving a remote 

START

 signal, Secure Lock will 

UNLOCK

the Doors (disarming the factory Alarm); 1/2 sec. after remote start Secure Lock will 

re-

lock 

the Doors. 4 seconds after shutdown, Secure Lock will 

re-lock 

all Doors (

arming 

the system once again). 

Please note 

that most OEM systems will 

not 

rearm the Alarm 

while the Engine is running, but 

will still lock the Doors. 

Smart Secure Lock 

If the vehicle is initially locked, upon remote 

START

 the Remote Car Starter will trigger an 

unlock pulse 

and a 

disarm pulse 

before the Engine is started. The Remote Car Starter 

will 

LOCK

 again when the Engine is running, and 

LOCK

 once again 4 seconds after shut-

down. 

If the vehicle is initially 

unlocked

, upon remote 

START

 the Remote Car Starter will start 

the Engine and arm the Starter Kill, but the Doors will not be locked or unlocked at any 

moment of the sequence. 

Lock Pulse Duration 

The duration of the Lock and Unlock pulses can be configured as follows: 

•

(Default) 7/10-sec. 

LOCK

 and 7/10-sec. 

UNLOCK

 pulses 

•

4-sec. 

LOCK/UNLOCK

pulses  to control vacuum Door Lock systems 

•

A 

single 7/10-sec. 

LOCK

 pulse and

 two 1/4-sec.

UNLOCK

 pulses 

 for double-pulse disarm/unlock systems. 

•

1/10-sec. 

LOCK

 and 1/10-sec. 

UNLOCK

 pulses 

Engine Run Time 

Use this Function to configure the length of time the Engine will be left running under 

remote control. The Remote Car Starter will allow the Engine to run for either 

4, 15 or 25

min. in Gas Mode and 

9, 20 or 30

 min. in Diesel Mode. Standard default Run Time is 15 

minutes in Gas mode and 20 minutes in Diesel mode. 

Starter Kill (Installation) 

The Remote Car Starter is equipped with a selectable 

Passive 

or 

Active-arming Starter 

Kill 

circuit that will prevent the vehicle from being started with the Ignition Key when the 

Remote Car Starter is armed. The Starter Kill wire will provide a constant 500-mA. 
negative output when the system is 

armed 

(locked by remote control) and can be 

connected to an external Starter or Ignition interrupt relay (see diagram below).  

The Starter Kill circuit can be set to arm in either 

Passive Mode

 or 

Active Mode