P. 10
User Guide
Safe Start
If this feature is enabled, the user must press the
START/STOP
button twice within 3 seconds to
remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing
with the transmitter.
•
To remote-start your vehicle if
Swap Start Mode
is selected, press
AUX
and then
LOCK
.
•
The
AUX 2
output can be activated by pressing the
START/STOP
button.
Installer-Programmable Valet Mode
“Home Valet
™
” Mode
If configured at installation, this feature will set the vehicle to a no-remote-start mode: if the vehicle
is parked indoors, there is no danger of it starting accidentally by remote control.
Note:
Once the Home Valet Mode is activated, the vehicle will not start by remote but the
OEM alarm functions will still be enabled.
To take the system i n t o Home Valet Mode:
•
Press the
LOCK
or
UNLOCK
button.
•
Within 3 seconds, press the
START/STOP
and
LOCK
buttons simultaneously.
The transmitter will beep twice.
•
Release the
START/STOP
and
LOCK
buttons.
The
START/STOP
and
LOCK
buttons will flash twice and the parking lights will come
ON
for 2
seconds.
To take the system o u t o f Home Valet Mode:
•
Turn the ignition key to the
IGNITION ON (RUN)
position.
The system will warn you if someone attempts to start your vehicle while it stands in Home Valet
Mode:
•
The transmitter will
beep twice
.
•
The
START/STOP
and
LOCK
buttons will
flash twice
.
•
The parking lights will:
Turn
ON
then
OFF
; then
Flash
twice
, pause; then
Flash
twice
again.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
If the vehicle has an automatic transmission, proceed as follows to set the system to Turbo
Mode:
1)
With the engine running, make sure to release the brake pedal and press the
LOCK, UNLOCK
or
START/STOP
button on the transmitter until the parking lights come
ON
.
2)
Remove the ignition key from the ignition switch.
The engine will continue running.
3)
Exit the vehicle and close all doors, hood and trunk.
4)
Press the
TRUNK
button; this will lock the doors, arm the OEM-style alarm (if
configured|) and confirm that the vehicle is in Turbo Mode.
5)
The engine will shut down after 60 seconds.
If the vehicle has a manual transmission, follow all steps of the Ready Mode routine (see
“Ready Mode Option” in this Guide) to activate Turbo Mode. At the last step, press either:
1)
LOCK
to lock the doors and have the engine shut down after 60 seconds;
The parking lights will flash 3 times and remain lit.
The OEM-style alarm and starter kill (if configured) will be armed.
