P. 8
Installation Guide
When the user remote-starts the vehicle:
•
The System will power up the Ignition circuit and wait
to engage the Starter Motor while the Glow-plug
indicator light is still on.
•
The System will engage the Starter Motor as soon as
the Glow-plug light (+) goes out.
o
Minimum waiting time is 3 seconds.
o
Maximum waiting time is 18 seconds.
If no Glow-plug wire is found on the vehicle, the Glow-plug
input on the System may be “timed out”. The System will
power up the Ignition and Glow-plug circuits and simply
wait for the time-out before starting:
•
Connecting the Glow-plug input wire of the System
to
Ignition
will hold the ignition
ON
for the maximum
waiting time (18 sec., recommended).
•
Keeping the Glow-plug input wire of the System
unconnected
will hold the ignition
ON
for the
minimum waiting time (3 sec., not recommended in
very cold environments).
Connect the Glow-plug wire to the Ignition wire only after
the Tach programming has been completed: connecting the
Glow-plug wire is one of the very last steps in the
installation process.
2-Pin Harness
Wire
Colour
Function
Description
1
BLUE/
WHITE
(–)
AUX 2
output
This 500 mA negative output can be programmed for one of the
following Options:
1.
Constant while the
LOCK
and
UNLOCK
buttons are pressed
simultaneously, + 1 sec. after the buttons are released.
2.
Pressing
LOCK
and
UNLOCK
simultaneously toggles the output
ON
and
OFF
with automatic toggle
OFF
after 30 seconds.
2
YELLOW
(–) Parking
Light output
500 mA negative Parking Light output.
Flashing the Hood Pin Switch
Flashing the hood pin switch is a procedure that brings the system into programming mode. Once
the system is in programming mode, the installer will have up to 20 seconds to select one of the
sub-menus. if the installer fails to select a sub-menu before the 20-second delay, the system will
exit programming mode and the installer will have to flash the hood pin switch once more.
Tip:
As long as the Hood is up, you may use the Programming Assistance Button instead of
the Hood Pin switch.
Here are the steps which the installer must follow in order to
flash the Hood Pin switch
:
The Installer …
The Module …
1.
Press and
hold
the Hood Pin switch for 4 seconds.
2.
Release
the Hood Pin switch.
The Parking Lights will turn
ON
.
3.
While the Parking Lights are
ON
,
press down
the
Hood Pin switch once more.
4.
Release
the Hood Pin switch again.
Caution!
If you press down and release the Hood
The Parking Lights will stay
ON
for 20 seconds
