P. 4
User
Guide
seconds later, the engine will start
the parking lights will remain on during the pre-programmed
run time of the engine
. The remote control will play a second melody to confirm that the engine has
started. If the vehicle does not start at the first attempt, the system will shut down. If your vehicle is
equipped with an automatic transmission, there will be 3 start attempts before the system gives up.
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to disarm and unlock the
doors. Enter the vehicle and do the following:
•
Turn the ignition key to the
IGNITION ON (RUN)
position. (
Do not turn the key
to the
CRANK
position while the engine is running. This would cause the starter motor to re-engage.)
•
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Using the System
Arming and Disarming the System
To disarm the alarm and starter kill (if installed) and unlock the doors (if installed):
1.
Press and hold the
UNLOCK
button for approximately 1 second.
There will be two chirps if the siren or horn is so configured.
2.
The
icon will appear, the parking lights will
flash twice
and the L.E.D. will flash quickly
to confirm that the doors have been unlocked and that the starter kill (if installed) and the
alarm are disarmed.
In passive mode, the system will rearm automatically 30 seconds after unlocking unless the key is
meanwhile inserted in the ignition switch (see description of passive mode later in this guide).
To arm the alarm and starter kill (if installed) and lock the doors (if installed):
1.
Press and hold the
LOCK
button for approximately 1 second.
You will hear
one chirp
if the siren or horn is so configured.
2.
The
icon will appear, the parking lights will flash once and the L.E.D. will flash slowly to
confirm that the doors have been locked and that the starter kill feature (
if installed
) and the
alarm are armed.
Idle Mode
Convenience feature:
Idle mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no key in the
ignition switch) while the engine is running. For example, if you stop for a delivery or at a conveni-
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
To leave the vehicle in Idle Mode if your vehicle has an automatic transmission:
1.
With the engine running, press the
LOCK
or
UNLOCK
button (to unlock the doors) or the
START/STOP
button on the remote control until the parking lights come on.
2.
Remove the key and exit the vehicle. The engine will go on running.
3.
Lock the doors if needed.
The engine will go on running until the user re-enters the vehicle or until the expiration of the
Engine Run Time.
If your vehicle has a
manual transmission
, Idle mode can be activated through the same routine
as that used for ready mode; at the last step, the
TRUNK
button is pressed instead of the other
buttons:
1.
Ensure that all the doors are closed and that the shifter is in the neutral position.
2.
With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
