handleiding/manual
www.autostyle.nl
Usage
Left (large button) arm/disarm
A.
Arm the system
Chirp once, lamp flash once, Led flash slowly.
Will start to sense the door open or ignition on 2 seconds after armed.
And will start to sense the sensor 30 second after armed.
Will chirp & flash 3 times if door is opened while arming.
B.
disarm the system
Chirp twice, lamps flash twice.
C.
Siren Stop
When alarm siren is triggering, may press this button to stop the siren sounding and system still keep in armed.
Right (small button) car locator/trunk release
A.
Car locator/warning away
In armed state (5 seconds after the system is armed), holding down the right button for seconds will activate the siren chirps
& lights flashing to help locate your car to warn away.
B.
Trunk release
In the disarmed state, hold down the right button 2 seconds, the parking light will flash 5 times, and the system will output a
trunk releasing signal (external relay required).
Additional Convenience
A.
Power locks remote control
If the door lock interface has been installed, the doors will automatically lock/unlock when the system is armed or disarmed.
B.
Power locks timing control
Please see the remote table power-lock timing setting for 0,5 second or 3,5 seconds door locking timing setting.
Status Led
Flash slowly: system armed
Flash fast: during the 30 second double re-locks (double re-arm) checking.
The parking lights will be flashed once, twice or 3 times 5 seconds after remote disarm if the system had been triggered in your
absence.
Flash 1 times
: ultra soon sensor was trigger
Flash 2 times
: door was opened
Flash 3 times
: ignition was trigger
Siren or car horn sounding selection
Please see the remote table siren or horn setting for selecting the siren or horn sounding.
System override
Please see the remote-table system override setting to disarm the system if lost the transmitters (does not matter system is in
arm or disarm state). The system will be triggered (like siren sounding etc). for one minute if the ‘’system override’’ was set, and
will be disarmed automatically after the one minute trigger.
Remote-table Operation
A. The system must be in disarm state except the ‘’system override’’ setting.
B. Open the door and let it opened.
C. Switching the ignition key, ‘’off’’ – ‘’on’’ several times which depend on which feature setting you want to set.
*like code-learning setting, you must switching ignition key ‘’off’’-‘’on’’ 7 times, then keep the ignition key at ‘’on’’ position at last
time.
MAnUAL Te 666FU
Read this before starting the installation!
AutoStyle is not responsible for consequential damages resulting from incorrect installation!
