11
FIGURES
(P. 28-31)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1)
PROTECT-LED and POWER-LED
(2)
Input Sensitivity Switch
(3)
Gain level controller
(4)
Sub Sonic filter controller
(5)
Audio signal inputs
(6)
Audio signal outputs for additional amplifiers
(7)
Low Pass filter controller
(8)
BASS EQ controller
(9)
Connector for the included bass level remote controller
(10) PHASE controller
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1)
GND terminal for the ground
(2)
REM terminal for the turn on connection
(3)
+12 V terminal for the positive-connection of the battery
(4)
Vehicle’s battery
(5)
In-Line Fuse (not included in the scope of delivery)
(6)
Turn on wire from the head unit or the electrical antenna
(7)
Fuse(s)
(8) MASTER/SLAVE switch
(9) Connector for the included MASTER/SLAVE DATA LINK cable
1-CHANNEL OPERATION MONO 2 SUBWOOFERS (FIG. 4)
If you want to run the amplifier with the 2 line output channels from the head unit to drive two subwoofers, con-
nect the following setup:
(1) To the head unit, line output left or subwoofer output
(2) To the head unit, line output right or subwoofer output
(3) Bass level remote controller
(4) Subwoofer 1 (2 - 8 Ω)
(5) Subwoofer 2 (2 - 8 Ω)
1-CHANNEL OPERATION MONO 1 SUBWOOFER (FIG. 3)
If you want to run the amplifier with the 2 line output channels from the head unit to drive a subwoofer, connect
the following setup:
(1) To the head unit, line output left or subwoofer output
(2) To the head unit, line output right or subwoofer output
(3) Bass level remote controller
(4) Subwoofer (1 - 8 Ω)
MASTER/SLAVE OPERATION WITH TWO TA1800 (FIG. 5a-5c)
If you want to run amplifier 1 with the 2 line output channels from the head unit and amplifier 2 should be con-
trolled via BRIDGE MODE (Fig. 2,9), connect the following setup:
(1) To the head unit, line output left
(2) To the head unit, line output right
(3) Bass remote control to adjust the bass level out of the driver’s seat
Note:
Set the switch BRIDGED MODE (Fig. 2,8) on amplifier 1 to position “MASTER” and on amplifier 2 to
position “SLAVE”.
