16
Fig. 16 – Cutting of the line before installation.
3.6
Installation of the temperature sensor (optional).
The temperature sensor (Fig.17) measures air temperature in the area of its installation
and allows running the heater in a set temperature mode. Install the sensor in a convenient
(appropriate) place in the heated room.
The operation of the heater with a temperature sensor is described in the operation
manual of the control panel.
The maximum length of the sensor harness is 5 meters. Temperature regulation
depends on the location of the sensor.
Follow these recommendations, when installing the temperature sensor:
Install the sensor:
✓
in the largest heated cabin;
✓
in the middle position of temperature
distribution in the cabin;
✓
on a vertical internal wall of the cabin,
if possible;
✓
at a distance from sources of heat.
Do not install the sensor:
close to the deflector, to avoid the effect
of the flow of warm air;
near the gangway;
behind cushions or curtains or other
accessories;
in a direct sunlight;
close to the ceiling.
When the temperature sensor has been installed, lay the line up to the heater location.
Connect the shoe of the temperature sensor to the corresponding connector on the heater.
(pos.1 – chip, pos.2 – pin shoe)
Fig. 17 – Temperature sensor
1
5020
+2 0
12
±1
2
Красный
Черный
1
5020
+2 0
12
±1
2
Красный
Черный
Correct
Incorrect
Red
Black
