14
Clips which are not included:
Suzuki, Mercury with side mount or
tiller mount or tiller mounted kill switch.
These clips are specials and are available at no charge by calling
AUTOTETHER at 888-593-4181
If you have a clip which does not match any of the clips supplied by
AUTOTETHER please contact us
To install the Mercury style clip on your kill switch:
1.) You must have the toggle switch on your kill switch down or in the
OFF position.
2.) You must arm or cock Autotether actuator as shown in image 1b
3.) Position hole in mercury clip over toggle on kill switch then push up
to place toggle in up position or on.
4.) Installation is completed.
Using the clip removal tools:
1.)
Place wedge tool (2a) over actuator and place wedges over seam
between the actuator case and kill switch clip (2c).
2.)
With wedge tool still in place, place tang compression tool (2b) over
clip and line up pushers with tabs on actuator case (2d).
SUZUKI CLIP
This clip looks very much like the Honda
clip. The Honda clip will not work for the
Suzuki application
MERCURY CLIP
For side mount or tiller mount. This clip is
similar to the center mount clip but will not
work in that application.
1a
1b
