NOTE:
If the communication link with the vehicle is broken during
Monitor mode, the number in the lower right corner will
stop flashing.
6. Use the
t
and
u
arrow keys to step through the sensors (1 at a
time), and the
p
and
q
arrow keys to page through the sensors
(10 at a time) to view their real-time data.
7. When you are done viewing real-time data, press
MON
. The
number in the lower right corner will stop flashing.
8. Press
DATA
to exit Data mode and display the opening screen.
Before You Start
•
Clearing Trouble Codes will remove any Trouble Codes
from the vehicle’s computer. You can use this feature to
make sure vehicle repairs were done correctly by doing a
new scan after clearing the codes.
•
Your vehicle must be scanned before clearing trouble
codes. If
DATA
is pressed, and the vehicle has not been
scanned, the scanner will display
Press the Scan
key to Scan New Data
. Refer to “Key ON, Engine
OFF (KOEO) Scan” on page 33, “Key ON, Engine Running
(KOER) Scan” on page 35, or “Data Communications Link
(DCL) Scan” on page 38.
Clearing Trouble Codes
1. Make sure the EZ-SCAN scanner cable is correctly connected to
the scanner and to the vehicle. Turn the vehicle ignition key OFF
for at least 10 seconds, turn the key ON, then press
POWER
.
2. Press
DATA
to display the Data menu. Use the arrow keys until
4-Clear Codes
is highlighted, then press
ENTER
.
3.
ENTER to Clear
will be displayed on the screen. Press
Page 45
C
LEAR
T
ROUBLE
C
ODES
- F
ORD
V
IEW THE
DCL D
ATA
- F
ORD
(C
ONT
.)
Summary of Contents for EX-SCAN 5000
Page 1: ...USERS MANUAL...
Page 95: ...NOTES Page 95...
Page 96: ...NOTES Page 96...
Page 97: ...NOTES Page 97...
