This section gives the information you need to set up and operate
your EZ-SCAN Scanner:
•
Install New Batteries
•
Configure the Scanner for Your Vehicle
•
Set the Display Units (SAE/Metric)
•
Connect the Scanner to Your Vehicle
Install New Batteries
The EZ-SCAN Scanner is powered by 4 AA batteries.
Before the scanner is used the first time, you need to
install batteries in the unit.
Make sure the batteries are put in according to the diagram on the
back of the battery compartment door. Refer to the illustration
below.
Figure 2. Battery Compartment
•
If the screen becomes too dim to view, the batteries need to be
replaced. Replace all four batteries to avoid unit malfunction.
When it is time to change the batteries, the Data Holder
Feature will save all Data and configuration information if fresh
batteries are installed immediately after removing the old ones.
CAUTION:
Leaving used or dead batteries in the scanner
beyond the battery date may result in damage to the unit.
S
ETUP
/ O
PERATING
I
NSTRUCTIONS
Page 8
Summary of Contents for EX-SCAN 5000
Page 1: ...USERS MANUAL...
Page 95: ...NOTES Page 95...
Page 96: ...NOTES Page 96...
Page 97: ...NOTES Page 97...
