Line of Sight Infrared Hydrocarbon Gas Detector AutroPath HC800 , 116-P-HC800/IGB, Rev. A, 2016-03-03
P/N 95-8744, v4.2 , rev. 3/16
Autronica Fire and Security AS
Page 39
WarnInG
Always ensure that the detector/junction box hazardous (classifi ed) location ratings are applicable for the
intended use.
WarnInG
Potential electrostatic charging hazard on brow. Use caution when servicing in an explosive environment.
Additional Safety Notes:
• For ambient temperatures below –10°C, use fi eld wiring suitable for the expected conditions, and for ambient
temperatures above +60°C, use fi eld wiring and cable glands suitable for 15°C above the maximum expected
conditions.
ACCurACy (
per IeC 60079-29-4)
±5% of full scale gas concentration or ±10% of applied gas concentration, whichever is greater.
ReSPoNSe tIme
T90: 2 seconds (2.5 LFL-meters applied).
ALIGNmeNt
Misalignment will cause the manufacturer stated accuracy limits to increase, but remain within the limits of IEC
60079-29-4.
Accessories with the following part numbers are approved for use with the AutroPath HC800:
116-011773-001
Short Range Aperture Kit
116-012287-XXX
AutroPath HC800 Alignment Tool
116-009246-002
Gas Test Cell
116-012673-001
System Test Film
116-012312-001
Transmitter Brow
116-012300-001
Receiver Brow
116-012660-001
Mounting Bracket
116-103922-001
HART Handheld Communicator
116-011824-001
Modbus Program
116-102740-002
Calibration Magnet
NoTeS
Approval of the AutroPath HC800 does not include or imply approval of the apparatus to which the detector
may be connected and which processes the electronic signal for eventual end use. In order to maintain an
approved system, the apparatus to which the detector is connected must also be approved.
This Approval does not include or imply Approval of the communications protocol or functions provided by
the software of this instrument or the communications apparatus or software connected to this instrument.
Manufactured by:
Detector Electronics Corporation
www.det-tronics.com
