Introduction
Installation Handbook, AutroSafe Interactive Fire Alarm System, Release 3, 116-P-ASAFE-FA/DE,
Rev. J, 2011-12-06,
Autronica Fire and Security AS
1. Introduction
1.1 About the Handbook
This handbook is intended to provide all necessary information for the
installation of the AutroSafe Fire Alarm Control Panel (BS-310/320)
and the Controller BC-320. It also gives detailed information on
connections to the network (AUTROLON) and guidelines for the
installation and addressing of loop units.
Information on the connection of detectors and other loop units to the
detection loop is found in a separate handbook, Connecting Loop
Units, 116-P-CONNECTLOOPUNIT/GBD (pdf filname
connectloopunit_gbd).
The Fire Alarm Control Panel and the Controller are identical as far as
installation procedures are concerned. Note that all illustrations
throughout this handbook shows the Fire Alarm Control Panel with
buttons, indicators and display. The Controller has a front blackplate,
and the Display Board BSR-310, Operator Board BZ-310 and
Processor Board EAC-300 are not integrated parts of the system unit.
The chapter «Service and Maintenance» outlines the recommended
monthly and annual service and maintenance procedures.
1.2 The Reader
The handbook is intended to be used by Autronica Fire and Security
trained service and technical personnel who are responsible for the
installation of the AutroSafe Interactive Fire Alarm System.
Note that this handbook deals with the mechanical and electrical
installation only. All tasks described in the handbook are to be
performed without applying power to the system.
Power must not be applied before commissioning, refer to
Commissioning Handbook.
!
POWER OFF!
Summary of Contents for Autro Safe BC-320
Page 60: ......
