Service Commands
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 11
Access Level 1: No key or password required
Access Level 2: Access by key
Access Level 3: Password restricted
Menu Structure
English
Enter Service Mode
Service
System Settings
Loop Operation
Unit Configuration
Unit Test
System Topology
Export and Import
Save Configuration
Restart System
Day Mode Operation Times
Service Mode Password
Date and Time
Set Operator Panel Connection
Sound Patterns
Automatic Resound
DZ Delay Timers
DZ Global Dependency
Battery Parameters
Panel Name
Language
FARE and FWRE Disablement
Mains Power Fault Indication
Printer Setup
Configuration Check
System Shutdown
Restore Factory Settings
Enable Units
Disable Units
Change Disable Time Span
Show Polluted Detectors
Show Low Current Units
Detection Zones
Alarm Zones
Points
Fire Alarm Devices
Loop Outputs
Local Outputs
Loop Inputs
Local Inputs
Loop I/O Carriers
Mimic Panels
Activation Groups
External Interfaces
Detection Loops
Operator Panels
Detection Zones
Alarm Zones
Fire Alarm Devices
Loop Outputs
Local Outputs
Mimic Panels
Show Topology
Show All Faults
Clear Loop Config. – Restart System
Deactivate/Activate
Export Log
Select Configuration & Restart System
Backup Current Configuration
Export Configuration
Import Configuration
Exit Service Mode
(Functions)
116-P-APRIME2-MENUS/MGB, 2012-01-10
(Applicable only if Mimic
Panels are used)
Connect to Alarm Zone
Connect to Output
Connect to Disable Input Device
Connect to Local Alarm Delay Unit
Connect to Panel
(special panel only)
Disconnect from Alarm Zone
Disconnect from Output
Disconnect from Disable Input Device
Disconnect from Local Alarm Delay Unit
Disconnect from Panel
(special panel only)
Show Member Points
Show Connected Units
Connect to Neighbour Alarm Zone
Disconnect from Neighbour Alarm Zone
Show Member Fire Alarm Devices
Show Neighbour Alarm Zones
Show Activating Detection Zones
Move to Detection Zone (/Create New )
Connect to Output
Connect to Activation Group (/Create New )
Disconnect from Output
Disconnect from Activation Group
Show Connected Units
Move to Alarm Zone
Show Connected Units
Connect to Output
Connect to Activation Group
Disconnect from Output
Disconnect from Activation Group
Show Activating Detection Zones
Show Activating Points
Show Activating Inputs
Show Activating Groups
Show Activating Outputs
Move to Alarm Zone
(applies to FAD only)
Show Connected Units
Connect to Output
Connect to Alarm Zone
Disconnect from Output
Disconnect from Alarm Zone
Show Connected Units
Show All Carrier Units
Show Carrier Points
Show Carrier Inputs
Show Carrier Outputs
Configure
Show Mimic Inputs
Show Mimic Outputs
Connect to Output
Disconnect from Output
Show Member Points
Show Connected Units
(Not applicable to FAD, FARE and FWRE:)
(Not applicable to FARE and FWRE:)
Serial Port Settings
TCP/IP Port Settings
ESPA
MODBUS
VDR
Remote Access
Configure ESPA Settings
Configure ESPA Events
Configure ESPA Receivers Table
Send ESPA Test Event
Configure MODBUS Settings
Congigure Status Registers
Configure Command Registers
Set Testbit to 0
Set Testbit to 1
Assign Unique MODBUS Indexes
Configure VDR Settings
Send VDR Test Event
Server and Web Access
User Management
Clients
Client Proxy Server
Summary of Contents for Autroprime 2
Page 148: ......
