Introduction
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 9
1.4 Ready-to-use in a Pre-configured State
Autroprime
is provided to the user in a pre-configured state, in this
state the panel is set to recognize detectors and other loop units
connected to the detection loops and the availability of routing
equipment, etc. As such, the system is fully functional and ready-to-
use simply by turning ON the power, but not configured to respond
in any non-default way. A functional verification of the panel is run to
assure the panel itself is fully functional.
By default the system has one Detection Zone and one Alarm Zone.
A point in alarm will activate all Fire Alarm Devices and Fire Alarm
Routing Equipment.
Site-specific configuration can be performed by means of the panel
buttons. Refer to chapter 2.1,
Site-specific Configuration.
1.5 Saving a Configuration and Restarting the System
Note that you always have to save a configuration and restart the
system;
after an initial startup (part of the start-up procedure)
each time a configuration has been changed.
This menu selections are found in the Service Menu/System
Settings (see chapter 2).
1.6 Configuration Examples
Chapter 9 in this handbook deals with two configuration examples,
one basic configuration example and an example with several alarm
zones and control functions. These examples shows how to perform
typical configurations of a medium-sized installation (to simplify the
understanding of the configuration principle, the basic configuration
example deals with one loop and 8 points only).
Summary of Contents for Autroprime 2
Page 148: ......
