- 38 -
detected for this camera. Press ENTER in Settings.. to call up Video Loss
Setup display for the camera. Please refer to section 6.2.1 for the details.
Motion Detection –
whether the motion detection of this camera is enabled or
not. If enabled, the next item Motion Settings.. will be settable. Press ENTER
to check/uncheck this item. The default setting is “ˇ” - checked.
Motion Settings.. –
used to setup the motion settings for this camera. Press
ENTER in Settings.. to call up Motion Setup display for the camera. Please
refer to section 6.2.2 for the details.
Covert –
covert or not. If the camera is covert, the video of this camera can
only be seen if the user has logged in as Administrator. Press ENTER to
check/uncheck this item. The default setting is “–” - unchecked.
Call By Event –
whether to switch the call monitor to the video of this camera if
certain event occurs for this camera. There are 4 options, including Off, Motion,
Alarm, Both (Motion & Alarm). Press +/- buttons to select one.
Dwell Time –
the dwell time if Call By Event is set to Motion, Alarm, or Both.
Press +/- buttons to adjust the value (3-60 seconds, discrete).
Audio –
the AUDIO IN corresponding to this camera. The audio data for the
selected AUDIO IN will be recorded with the video data for this camera. Press
+/- buttons to select none (N/A) or one of the AUDIO Inputs (1-4). The default
setting is “N/A”.
Record Quality –
the record quality for this camera. Press +/- buttons to
select the value (1-9, with 1 the lowest (rough) quality, 9 the highest (fine)
quality).
Event Record IPS –
the IPS (Images Per Second) for this camera if certain
event (Motion, Alarm) occurs for this camera. This camera will be recorded at
this rate for Post-record time since the event occurs. (Please refer to the
following sections for Post-record time.) Press +/- buttons to select the value
(0 – 25 (PAL) / 30 (NTSC), discrete).
Pre-record IPS –
the pre-record IPS for this camera if certain event (Video
Loss, Motion, Alarm) occurs for this camera. This camera is recorded at this
rate for Pre-record time before the event occurs. (Please refer to the following
sections for Pre-record time.) Press +/- buttons to select the value (0 – Event
Record IPS for this camera, discrete).
Normal Record IPS –
the normal record IPS for this camera. This camera
will be recorded at this rate if no event occurs. Press +/- buttons to select the
value (0 – Pre-record IPS for this camera, discrete).