AEDx-8xxx-xxx
Assembly Guidelines
2- or 3-channel Incremental Encoder Kit
Application Note 5435
Description
This application note gives step-by-step instructions for the alignment and installation of the AEDx-8xxx series incre-
mental encoder to a motor shaft.
Delivered pre-assembled with
an Allen key attached to the
module
Plastic
base plate
External
mounting
ear option
AEDx-8xxx series components
Install the Encoder to the Motor Shaft
Alignment jig
Guide poles
Step 1. Secure the baseplate
a) Partially screw-in two M2 screws to the motor.
b) Place the jig onto the motor shaft and center it to the inner diameter opening of the
baseplate.
c) Tighten the screws firmly (recommended tightening torque is 0.6 in-lb (0.7 kgf-cm).
d) Remove the alignment jig.
