5
LEVELING:
The beverage refrigerator should be installed on a firm and level surface that will be able to support the
entire weight of a fully loaded unit. It is important for the beverage refrigerator to be leveled in order to
work properly. It can be raised or lowered by rotating the plastic sheaths around each of the feet on the
bottom of the machine. If you find that the surface is not level, rotate the feet until the beverage
refrigerator becomes level. You may need to make several adjustments to level it. We recommend using a
carpenter’s level to check the machine. Turn the leveling feet to the right to lower that side of the
refrigerator. Turn the leveling feet to the left to raise that side of the refrigerator.
RECOMMENDED GROUNDING METHOD:
For your personal safety, this appliance must be grounded. It is equipped with a power supply cord having a
3‐prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3‐
pronged wall socket, and grounded in accordance with the National Electrical Code and local codes and
ordinances. If a mating wall socket is not available, it is the personal responsibility of the customer to have a
properly grounded, 3‐prong wall receptacle installed by a qualified electrician.
Before you move your beverage refrigerator into its final location, it is important to make sure you have the
proper electrical connection. A standard electrical supply (115 V, 60Hz), properly grounded in accordance
with the National Electrical Code and local codes and ordinances, is required. It is recommended that a
separate circuit, serving only your beverage refrigerator, be provided. Use receptacles that cannot be
turned off by a switch or pull chain.
The fuse (or circuit breaker) size should be 15 Amps.
Installing Your Door Handle and Shelves
INSTALLING THE DOOR HANDLE:
1.
Open the door and carefully pull the door gasket around the area where the handle is to be installed.
2.
Insert each Phillips head screw through the gasket side of the door until the screw passes through the
door.
3.
Align the handle with the screws and tighten using a Phillips head screwdriver until the handle is flush
against the door frame.
Caution: Do not over‐tighten the screws as this may cause damage to the handle or to the stainless steel
door.
4.
Carefully press the door gasket into its original position.
Electrical Shock Hazard!
Plug into a grounded 3‐prong outlet.
Never remove the grounding prong from the plug.
Never use an adapter to bypass the grounding prong.
DO NOT use an extension cord.
Failure to follow these instructions can result in fire, electrical shock, or personal injury.
