6
INSTALLING THE SHELVES:
1.
Open the door completely.
2.
Line up the shelf notches with the rail posts on both the right and left sides.
3.
Push the shelf down and then push it all the way inwards until the shelf fully rests inside of the unit and
you are able to close the door.
4.
The shelf should glide smoothly back and forth. If it does not, you may need to remove it and start over.
REMOVING THE SHELVES:
1.
Open the door completely.
2.
Remove all of the contents loaded on the shelf, if applicable.
3.
Line up the shelf notches with the rail posts as indicated below. This will require you to hold on to both
rails as you move the shelf to line up the posts with the notches on both sides of the shelf.
4.
Evenly lift the shelf up and then pull the shelf out.
Tip: To prevent damaging the door gasket, make sure to open the door fully before pulling the shelves out
of their tracks.
Note: This model is manufactured with all rails pre‐installed for maximum storage capacity. Our factory
default is to include a pre‐installed display shelf designed to accommodate most 750 ml wine bottles.
Additionally, we include three extra storage shelves for those who opt for more storage capacity. If you
choose to utilize the included display shelf, most users will have no functional issues gliding the display
shelf back and forth with the factory installed rail above the display shelf still installed. However, some
larger Burgundy bottles may contact the overhead post. If this happens, we recommend you remove the
interfering rail and re‐install just the Philips head screws in the cabinet so there are no holes left agape.
Tip: Safely store any removed hardware for possible future use.
