Avallon AWC242SZLH, Owner'S Manual

12

Installing the Shelves

Removing the Shelves

To prevent damaging door gasket, make sure to open the door fully before pulling the shelves off their tracks.

1. Open the door completely.

2. Push the shelf tracks affixed to the walls of the inner cabinet to the rear of the unit so that the tracks are fully 

seated inside the cooler compartment.

3. Line up the rails affixed to the shelf with the corresponding tracks attached to the inner cabinet walls.

4. Push the front of the shelf inward evenly until it rests fully inside the unit and you are able to close the door.

5. The shelf should glide smoothly back and forth. If it does not, you may need to remove it and start over.

1. Open the door completely.

2. Remove all of the contents loaded on the shelf, if applicable.

3. Pull the shelf towards yourself until it is fully extended outward.

4. The shelf has plastic posts on both sides as indicated in the diagram below. While facing the unit, press the 

plastic post on the right side down while pulling up on the left plastic post. You may choose to do this by hand or 

by using a flathead screwdriver.

5. Evenly pull out the shelf from the track until it is completely removed from the inner compartment.