Avallon AWC242SZLH, Owner'S Manual

11

Leveling the Refrigerator

The refrigerator should be installed on a firm and level surface that will 

be able to support the entire weight of a fully loaded unit. It is important 

for the refrigerator to be leveled in order to work properly. It can be 

raised or lowered by rotating the plastic sheaths around each of the feet 

on the bottom of the machine. If you find that the surface is not level, 

rotate the feet until the refrigerator becomes level. You may need to 

make several adjustments to level it. We recommend using a carpenter’s 

level to check the machine. Turn the leveling feet to the right to lower 

that side of the refrigerator. Turn the leveling feet to the left to raise that 

side of the refrigerator.

Important: 

Once you are ready to install the unit in a cabinet or directly on the floor, you must 

adjust the feet to level the refrigerator.

!

Installing the Door Handle

Caution: 

Do not over-tighten the screws as this may cause damage to the handle or to the stainless 

steel door.

!

To install the door handle:

1. 

Open the door and carefully pull the door gasket around the area where the handle is to be installed. 

2. 

Insert each Phillips head screw through the gasket side of the door until the screw passes through the door. 

3. 

Align the handle with the screws and tighten using a Phillips head screwdriver until the handle is flush 

against the door frame. 

4. 

Carefully press the door gasket into its original position.