Opera
Ɵ
on
INSTALLATION CHECK LIST BEFORE OPERATION
1. Have all packing materials and tape been removed from the interior and exterior of the wine refrigerator?
2. Have the installa
Ɵ
on instruc
Ɵ
ons been followed, including connec
Ɵ
ng the machine to electricity? And has proper
grounding been installed for the wine refrigerator?
3. Has the machine been leveled?
4. Is the wine refrigerator in a site where the ambient temperature is between 50º F and 95º F all year round?
5. Is there a clearance of at least 2 to 3” at the rear for proper air circula
Ɵ
on?
USING YOUR CONTROL PANEL
This wine cooler has a temperature range from 40°F to 65°F.
F
C
POWER BUTTON: Press and hold down for three seconds to power your unit on, once pressed the “Run” in-
dicator light will illuminate to indicate the unit is on and running. Press and hold for three seconds again and
the unit will power o
ī
and the “Run” Indicator light will turn o
ī
.
INCREASE TEMPERATURE: Press to increase the temperature by 1 degree increments.
DECREASE TEMPERATURE: Press to decrease the temperature by 1 degree increments.
INTERIOR LIGHT: Press this bu
Ʃ
on to turn on the interior LED light. Press again to turn the light o
ī
.
SELECTOR BUTTONS
INDICATOR LIGHTS/DISPLAYS
RUN
F
C
Note: Allow at least 24 hours for your wine cooler to run before storing your wines and to allow the temperature to
acclimate. Whether your wine cooler can reach the actual set temperature depends on the ambient environmental
condi
Ɵ
ons.
Tip: If you powered o
ī
the unit, please wait at least 5 minutes before powering it back on.
When lit, the unit is in cooling mode.
This unit can be displayed in Fanrenheit or
Celsisus. To change between press and hold the
Increase and Decrease Temperature bu
Ʃ
ons at
the same
Ɵ
me for
Į
ve seconds. A sound will then
beep and the indicator light will illiuminate next to
desired temperature se
ƫ
ng.
Temperature Display: Shows the
set temperature and current
temperature in the upper zone.
