3.
Initial EVO-zero Setting
The EVO-zero has been designed for the T-pod 70 but is also compatible with the T-pod 90, so,
in the next paragraphs will be described the operations required to fix this mount on one of
them.
The operations described here require the EVO-zero to be firmly set on the T-Pod tripod.
Therefore the first portion of this chapter will describe the operation needed to set up the tripod
and install the mount on it.
However, the EVO-zero is also compatible with photographic tripods that allow the use of 3/8”
fixing knob.
1.1
T-pod Mounting
The T-pod 70/90 setup is very simple. The operations to perform are the following:
•
Place the T-Pod tripod head up with the legs on the ground. After loosening the knobs on
the legs, adjust their length to the desired height.
•
Pull the legs outward by extending the three tie-rods until they click in fully opened
position.
•
By using the EVO-zero with a T-pod 90 or a T-pod 70, it will be possible to assemble
the StarGo controller on one of the tripod legs thanks to the matching holespacing as
described on the sequenced pictures below.
We suggest to perform this operation before to put the mount on the tripod, in order to operate
in a more safe and secure situation.
©
All Rights reserved
11
Summary of Contents for EVO-ZERO
Page 10: ...All Rights reserved 10...
