Place the brass latitude adjustment plug over
the set of holes (1, 2 or 3) corresponding to
the needed latitude range as described on the
previous page. Re-attach the brass plug in
the preferred latitude range position using
the screws removed earlier. The mount is
shipped from the factory with the brass post
in position 2.
Re-attach the side plate using the four screws
1, 2, 3 and 4, previously removed.
Next, replace the two screws previously
removed from under the mount
3.2
Installing the M-Uno on the Tripod
Whatever type of tripod is used it must be mounted with the right orientation. This need that the
brass contrast block which is installed over the tripod mounting plate, is oriented to the North
with sufficient approximation. A mechanical or digital compass can be used to perform this task.
The M-Uno comes with a plate for attaching the mount on the tripod. It is shipped with the
correct holes for most of the tripods available on the market. The following figure shows how to
mount it on a T-Pod:
©
All Rights reserved
-
12
