The procedures can also be used after the Sync Home Position, simply starting from point
2
3.2.3 AUX Panel
Clicking on the “AUX” tab brings up a panel (Figure
.2.3.a) that controls the setting of one
auxiliary port dedicated to a Baader Steeldrive focuser (for StarGO Bluetooth version only)
and the two AUX 1 and 2 ports controllable by the StarGO. These ports can drive stepper
motors for specialized functions such as generic focusers, filter wheels, CCD rotators, etc.
The “STEELDRIVE” frame only allows the setting of a decimal number (see note below)
because all other parameters are fixed and internally set by the focuser’s manufacturer.
The two frames below, AUX1 and AUX2, contain the parameters pertaining to the auxiliary
devices as follows
Step/mm – Step/degree:
Device speed measurement selection (linear/angular) and
related values.
Decimal:
Number of decimal to be shown in the main panel (see
c
) and in the separate windows (see section 3.4).
Show checkbox:
Show or Hide the controls in the main panel (see figures
b
c ).
Reverse checkbox:
Reverse the motor movement direction.
The SHOW BUTTON frame check box is for show/no-show the DSLR in the main panel.
____________________________________________________________________
©
All Rights reserved
30
Figure 3.2.3.a. “AUX” Panel
Figure 3.2.3b: SHOW BUTTONS
checked…
Figure 3.2.3c: ... and unchecked
